MAX14906EVKIT#

MAX14906EVKIT# is a MAX14906 evaluation kit (EV kit) which provides a proven design to evaluate the MAX14906, a four-channel industrial digital-output, digital-input device. The EV kit allows the MAX14906 to be configured on a per-channel basis as either a digital output (in High-Side switch or Push-Pull driver configuration) or a Type 1 and 3, or Type 2 digital input. The EV kit monitors the MAX14906 diagnostic information, including open-wire condition, state of the output channels, multiple undervoltage alarms, global and per-channel overtemperature alarms, and multiple fault alarms. The EV kit must be powered from an external 24V DC power supply that can provide up to 6.4A (max), when all DOI_ output channels are fully loaded with the option of 2x load inrush current. The MAX14906 EV kit comes with the MAX14906ATM+ installed in a 48-pin, 7mm x 7mm QFN package.

• Easy evaluation of the MAX14906 with per-channel configuration
• SafeDemag™ for safe turn-off of unlimited inductance in digital output modes
• Configurable for IEC 61131-2 Type 1 and 3 or Type 2 digital input
• Support up to 3.75kVRMS galvanic isolation with MAX14483 and MAX14937
• Support communicating with external microcontroller or FPGA
• Allow output switching with high-speed parallel interface or SPI serial interface
• Windows® 10, Windows 8.1, and Windows 7 compatible GUI software
• Proven PCB layout
• Fully assembled and tested
• On-board FT2232 controller interfacing to the MAX14906 control signals

Notes

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party