Low

FTDI  UMFT201XB-NC  Breakout Module based on FT201XQ USB to I2C Slave Interface Chip - Solder Ended Connection

FTDI UMFT201XB-NC
Technical Data Sheet (669.03KB) EN See all Technical Docs

Image is for illustrative purposes only. Please refer to product description.

Product Overview

UMFT201XB-NC breakout modules utilize FT201XQ chip to convert USB to serial interface. UMFT201XB bridges from USB to I2C IC. This hardware is a low cost breakout board form factor that converts USB2.0 full speed to a serial interface and connects the serial signals to a 2.54mm (0.1inch) pitch 10pin female receptacle. The boards do not use a USB connector, but instead the modules plug directly into the USB host connector and the pads of the PCB makes electrical contact with the electrical contacts of the USB connector. This modules operate at +3.3V voltage levels, however all I/Os are 5V tolerant.
  • Single chip USB to I2C slave interface
  • Up to 3.4MHz, high speed mode, I2C supported
  • Entire USB protocol handled on the chip. No USB specific firmware programming required
  • Royalty free VCP and D2XX drivers eliminate the requirement for USB driver development in most cases
  • Configurable CBUS I/O pin
  • Transmit and receive LED drive signals
  • Device supplied preprogrammed with unique USB serial number
  • Integrated power on reset circuit
  • UHCI/OHCI/EHCI host controller compatible
  • USB 2.0 Full Speed compatible

Product Information

Silicon Manufacturer:
FTDI
Silicon Core Number:
FT201XB
Kit Application Type:
Interface Module
Application Sub Type:
USB to I2C
Kit Contents:
Dev Board FT201XB
Product Range:
-
Features:
Full Speed USB2.0, 4 Control Bus Lines, 8 Pads on the PCB I2C, Embedded ROM, 3.3V O/P, USB Powered
SVHC:
No SVHC (17-Dec-2015)

Find similar products  grouped by common attribute

Applications

  • Communications & Networking;
  • Industrial;
  • Portable Devices;
  • Consumer Electronics;
  • Wireless;
  • Sensing & Instrumentation;
  • System Monitoring

Legislation and Environmental

Country of Origin:
China

Country in which last significant manufacturing process was carried out

RoHS Compliant:
Yes
Tariff No:
84733020
Weight (kg):
.002

Similar Products

Find products functionally similar to this one. Select one of the following links, and you will be taken to a product group page that presents all products in this category that share the given attribute.